Trapezoid T05 - Ceiling and Facade Profiles

Trapezoidal sheets are produced on new modern technological lines, with the high accuracy and speed processing. A thorough inspection of the entire production process, guarantee quality of supplied sheets. Steel trapezoidal profiles are produced by cold forming of surface-treated steel sheet.
 
For trapezoidal sheet is recommended roof slope of 8 degrees.
 
Used materials:
  • Galvanized steel sheets of different grades of zinc coat from 200 g / m2
  • Lako-plastic metal sheet made from a steel,  sheet metal hot dip galvanized on both sides, zinc coating at least 200 g / m2, passivation, protective paint thickness min. 7 microns.
  • Lako final layer consists of a plastic-coating on polyester basis, width min. 25 mic.
  • Durability of the treated sheets, under normal conditions min. 40 years.
Trapezoidal sheets can be made of aluminum, copper, titanium-zinc sheets and the other materials determined by the agreement.

Profile height is 3 mm. Using of this type is constrained on ceiling or facade plate. It is suitable for cladding various interior or exterior walls, extentions and so on. When we use it in exterior, it is recommended to give the double-sided adhesive tape for moisture protections which is offered in accessories. It is not suitable as a roof profile.

t05 

Total width Effective width Material thickness Production length
 1245 mm 1215 mm from 0,50 mm from 0,4 m
    to 0,75mm to 8,0 m