Fold roofing - description

Falcovaná strešná krytina
On roofs with a small slope where it is not possible to use the classic lightweight roofing it is recommended seamed roof with stand-rebated 25 mm.
 
Remodeling standing rebate on strips made exactly to length according to customer requirements.
 
Skived roof is suitable for low slopes according to watertightness joints. Its determination is wider. It is also used on pitched and the various atypical roofs with round turrets and floor plan below.
 
Technical specifications:
Material suitable for reworking:
  • Titaniumzinc - copper - aluminum to a thickness of 0.8 mm
  • Steel sheet, galvanized or plated with organic coating to a thickness of 0.65 mm
  • Stainless steel - stainless steel to a thickness of 0.5 mm
  • All metal strip between the width from 230 to 840 millimeters can be formed into the straight shape.
  • The minimum length piece is cca 500 mm.
 
Snow gripper
We use two basic types: one-hole clip with a hole for one pipe and two hols for the second pipe. In addressing the design and proper use of snow trap for welted roofing is necessary to consult with our sales managers. The snow trap are included following accessories: End plastic plug, clutch pipes for conection, end secure against the upper tube movement.

snehovy s nadstavbou falcsnehovy falc jednodierovy

The actual installation of terminals is very simple and fast: clamp is attached to the vertical decrease cca.10 mm from the bottom plate securing screws. Locking screws are made of stainless steel and is fully tightened after can not be re-authorize and just make permanent joints. This design ensures that the terminal did not allow a sliding after decreasing. When we are anchoring the clamps on vertical seam, lower aluminum tube is pushed and secured movement of relative displacement clamping terminals. Where fitted twin-tube snow guard the body to the other side of the pipe attached to the terminals and the oven is ensured against displacement snap rings in the number of 4 pcs per 6 m pipe.

snehovy falc jednodierovy
Snow gripper for standing seam roofing TERMINAL ONE Hole
  • It consists of left and right parts and two locking screws with matrices.
  • Clamp material: aluminum size 6mm width 50mm
  • Terminal finish is natural aluminum.
  • Screening M12x30 bolts with matrices are stainless steel.
  • Designed for tube with Ø32mm
 
 

Snow gripper for standing seam roofs clamp with the body to the SECOND BAR
snehovy s nadstavbou falc
 
  • It consists of left and right parts and two locking screws with matrices and superstructure on the second hole.
  • Clamp material: aluminum size 6mm width 50mm
  • Terminal finish is natural aluminum.
  • Screening M12x30 bolts with matrices are stainless steel.
  • Designed for tube with Ø32mm.
  • To secure of the second pipe
  • STOP THE BAR against movement in the superstructure.
 
 
On the final closure of the bar is PLASTIC CAP.
 
CLUTCH PIPES - Merges the tubes if we need more length. By the end of the pipe connector is inserted and secured to Farmers' screw or rivet tear.
 
Spojka
 
Snow gripper for VERTICAL seam roofing material